Perfect for desoldering Through-hole and multi-layered PCBs.
TP-200 series are fitted with a diaphragm twin pump. TP-210 uses an ejector vacuum system which has a maximum pressure of -0.09MPa (-700mmHg) and reaches maximum 5 times faster than the TP-200/200AS. (External compressor required)
VARIABLE TEMPERATURE SETTING
The TP-200/210 series has a sensor feedback system with a temperature adjustment circuit that allows temperature setting from 250-450°C.
QUICK HEAT AND QUICK HEAT RECOVERY
Due to the speed with which the nozzle heats, set temperature can be reached in just 2 minutes even when set at 450°C.
NEW MECHANISM TO REDUCE BLOCKED SOLDER
When the trigger is pulled the heater is ON to boost temperature in order to compensate for reducing nozzle temperature during soldering. After the trigger is released, the vacuum pump automatically continues for about 0.5 seconds reducing the chance of solder jamming in the nozzle.
REPLACEABLE CARTRIDGE FILTER
New design makes removing the cartridge and changing the filter easy.
110-130V, 220-240V AC 50/60Hz
Temperature Setting Range
Temperature Control System
Sensor feed-back (ON-OFF control)
Over 100MΩ (500V DC)
Vacuum Pump System
Vacuum Degree Reached
- 0.08MPa (-600mmHg)
- 0.09MPa (-700mmHg)
Air Pressure Supplied
Trigger ON (Min.)
Trigger ON (Max.)
220x155mm (w/o cord bushing)
(w/o vacuum hose & cord
(w/o vacuum hose & cord)
0.3kg (w/o cord)
Less than 0.1mV
Less than 0.1Ω
Connecting Cord/ Hose Length
Power Cord/ Hose Length
1.5m (3 core cable) ground plug
Cleaning Pin TP-100CP07/ Soldering Iron Stand ST-76